|
|
|
|
Easy and inexpensive to install. You can do
it yourself.
They are built into a bolt-up rubber-seated coupling. Only one coupler is
necessary for installation. No welding required. They are compact and
lightweight. The heat exchangers can be installed in any position (horizontal, vertical, ect.).
You get a minimum gain of 5% plus in engine power over
conventional fan-radiator installations. No energy is required for driving a
fan. Practically no maintenance required. All cooling surfaces are made of heavy copper pipe & are assembled w/high alloy, bronze welding material.
Designed to operate under high pressures required by
Sprinkler Irrigation Systems. Designed to have no sand buildup. The free flow of water through the pipe eliminates sand buildup.
Units available in 5 to 16" sizes, with Double-end units
available.
Each unit is pressure tested & inspected . Each unit is unconditionally guaranteed for materials & workmanship.
HP Greater than 350 Brake can be Engineered & Designed to Specification.
Cooling Coil HP handling at water temperature of 60 degrees F or less. Standard pipe sizes are shown. Cooling Coils for odd size pipe such as 8" OD can be obtained upon request.
Pricing on the Full Flow Pipe Models can obtained by calling 806-357-2222.
|
|
Send mail to
gearn@steamflake.com with
questions or comments about this web site.
|
Plains Heat Exchanger
